kano2285
OBJECTIVE
Seeking an interview to secure a position as a Civil Engineer in a structural, transportation, or industrial engineering environment, construction management/engineering, or as a Sales Engineer/Sales Representative in any engineering application
EDUCATION
BS: Civil Engineering, Structures and Transportation, University of Utah, May 2005
Skills:
• Proficient in AutoCAD, Microsoft Word, Excel, and PowerPoint.
• Experienced in many Surveying/Field Engineering techniques.
• Familiar with MathCAD, MatLab, and Maple.
EXPERIENCE
Civil Engineering/Industrial Design/Field Engineering – HBC International (KUCC Contractor), 2005-Present
– Structural Design:
• Steel member selection for large, industrial structures located at Kennecott Utah Copper’s (KUCC) Smelter, Reverse Osmosis (R.O.) Plant, and Copperton Concentrator.
• Steel platform design for large, industrial loading for KUCC’s Smelter and Copperton Concentrator.
• Assisted in the structural support for a large conveyor located at KUCC’s Smelter.
• Designed small, steel structures located at KUCC’s R.O. Plant
• Concrete design for footings, slabs, retaining walls, shear walls, and small buildings; all for industrial applications.
• Created all structural engineering drawings using AutoCAD.
– Quality Control Field Engineering for KUCC’s AGV Replacement Project:
• Provided surveying support in preparation for and during the installation of a new system comprised of fixed position rails, storage racks, and transfer cars that replaced the old Automatic Guided Vehicles (AGV) system.
• Provided all Primary Control for construction of the entire project.
• Compliance Checks provided:
Verified correct location of contractor’s survey lines and points for construction.
Checked geometry of construction placement prior to pour and drilling.
Checked elevation of rail plates prior to grouting within 1/16”.
Checked rail alignment.
Aligned placements of racks within an elevation tolerance of 1/16”.
Provided 24 per day (with partner) field engineering coverage during the “shut down”.
Created a full set of AutoCAD drawings illustrating all rail plates, anchor bolt holes, racks, and positioning for the project.
Filled out and verbally communicated Field Inspection Reports each shift.
Worked directly with the KUCC Project Manager.
– Roadway Design:
• Designed 1 mile roadway for access to KUCC’s R.O. Plant from survey layout to final engineering drawings.
• Experience with horizontal and vertical profiles, grading, curvature, surface drainage, and storm water drainage system design.
• Created final roadway drawings using AutoCAD.
– Mechanical/Electrical/Industrial Engineering Drawings:
• Updated/Created P & ID drawings for KUCC’s R.O. Plant, Smelter, Power Plant, and pump houses.
• Created various As-Built drawings for piping, structural, mechanical, and many other applications for KUCC.
• Created electrical layout, loop, and schematic drawings for many KUCC applications.
• Created proposal drawings for a new bag house/scrubber design for KUCC’s Smelter.
• Created general arrangement drawings for many KUCC facilities.
• All engineering drawings were formulated using AutoCAD.
Research Assistant – University of Utah, Dept. of Civil Engineering, 2004-2005
– CoreBrace Testing:
• Formulated test proposal for CoreBrace, LLC on the hydraulic ram testing of six buckling-restrained braces used in the construction of IHC Intermountain Medical Center project
• Made sure the testing protocol met the criteria found in the July 2003 AISC-SEAOC Recommended Provisions for Buckling-Restrained Braces
• Formatted testing data results using Word, Excel, and AutoCAD
• Supervised by Dr. Larry D. Reaveley
– UDOT ...
Login or Register to view the full resume.