Process Engineer
Summary
• Over 7 years of process engineering experience in oil and gas industry
• Specialized in FEED, AIMS, detailed engineering design, process simulation, optimization, commissioning, monitoring, troubleshooting, revamping
• Experienced in specification of scope of work, preparing PFD, P&ID, mass and energy balance, DBM, writing reports
• Experienced in design and sizing of heat exchanger, distillation column, air cooler, line sizing and pressure profiling, design of slug catcher, specification of Pressure Swing Adsorption (PSA) packages, and preparation of data sheet
• Experienced in HAZOP, design / sizing of: control valves, PSV, drain system, blow down system, flare system, PWKO drum
• Profound knowledge of procedures, codes and standards of Shell, API 520/521, ASME Sec. VIII Div 1, BSI, TEMA, OSHA, ERCB directives/regulations
• Experienced in SAGD, CSS for production of heavy oil and bitumen
• Proficient in Aspen HYSYS, VMGSim, Aspen Flare System Analyzer, HTRI, PDMS (user), MS Visio, MS Excel, MS Word, MS PowerPoint
• Has met all requirements of PEO and will get my PEng soon
Experience
Rangeland Engineering, Calgary, AB 2011 to 2012
Process Engineer
Project: Cenovus - Suffield Ram Hill Gas Battery - AIMS, 4 MMSCFD gas
Project: Cenovus - Suffield A2 Gas Compressor Station - AIMS, 14 MMSCFD
Project: Pembina NGL - Red Deer Gas Fractionation and Storage, 73000 bpd liquid natural gas
• Involved in Asset Integrity Management System study and HAZOP of already built natural gas production batteries and compressor stations
• Developed PFDs from P&IDs, recommended improvement modifications to P&IDs, simulated the plant by HYSYS or VMGSim including MDEA sweetening unit, TEG dehydration unit, prepared HMB tables and wrote DBM
• Determined applicable and dominant relief scenarios for pressure relief valves and calculated the maximum relief capacities of PSVs using API 521 recommendations and sized them with SizeMaster.
• Wrote PSV narrative, and simulated and sized flare network using Aspen Flare System Analyzer.
• Performed drain system calculations, including maximum flow rates of blow by gases discharged through level control valves to FWKO and sizing the thief hatch and gooseneck, and wrote drain system reports.
• Calculated blowdown time and flow rates from pressurized vessels and compressors after emergency shutdown of plant and wrote blow down reports
• Involved in design of a new duplicated 73000 bpd liquid natural gas fractionation plant including simulation of dehydration of deethanizer by TEG and regeneration of TEG, pressure profiling and line sizing of TEG regeneration loop, simulating heat medium system and determination of required capacities of HM consumers, design and layout of heat medium system
CCERCI, Tehran, Iran 2008 to 2011
Process Engineer
Project: South Pars Phase 15 & 16 Gas Field Development, 2 bscfd of reservoir fluid
• Sized a slug catcher with a capacity of 1 bscfd and six 46" fingers
• Calculated pump capacities, hydraulics, and pressure profiling of MonoEthylene Glycol (MEG) Regeneration unit by PIPESYS and isometric drawings in PDMS.
• Simulated the Condensate Stabilizer Column by HYSYS and sized the trays using Koch-Glitsch Tower Sizing.
• Prepared training materials and taught courses about measurements,...
Login or Register to view the full resume.
