Objective
To obtain an entry level job relating to the field of Mechanical Engineering.
Education
University of New Mexico
Major: Mechanical Engineering, GPA 3.04
• graduation date: July 2015
San Juan College, Farmington, NM 2007-2011
Associate of Science degree in Engineering, GPA 3.28
Farmington High School, Farmington, New Mexico
Graduated: May, 2007
Intern Experience
Red Cedar Gathering Company, Durango, CO Summer 2014
Natural Gas Gathering and Treating
• Preformed a feasibility study on an energy recovery system that could potentially reduce the company energy consumption.
• Determined annual maintenance cost for the facility’s pumps to include in an economic analysis
• Collected data and determined gas generators fuel consumption to electric load ratio. Results would help to estimate the amount saved.
• Calculated hydraulic horsepower requirements for standard operation conditions that would be a base line for future references
• Preformed an economic analysis that required calling equipment vendors and getting quotes.
Navajo Agricultural Products Industry
Farmington, NM, Summer 2013
• Estimated annual yearly maintenance cost for elevated water towers.
• Locate and determine the status of travel water screens and the cost of repairs.
• Update operations and maintenance manuals for labor crews. Specifically for natural gas operations.
• Field work included manual labor fixing water pipe breaks, cleaning water canal screens and power washing pumping plants.
• Troubleshoot natural gas engines for maintenance and repairs with experienced mechanics.
Unirac Inc.
Albuquerque, New Mexico, Summer 2012
• Test set up for stress tensile test machine that involved clapping parts securely, drilling holes for joint connections. Results were used to verify factor of safety values.
• Re-organized technical auto CAD drawing database by naming files with the proper drawing number, part number and solar project name that the part was used in.
• Created story boards for new solar racking systems during their product development phase to highlight the systems technical advantages and disadvantages. Drawings were saved as references for future design projects.
• Observed solar panel installation during site field visits by electricians and documented assembly procedures to find new methods to decrease construction time.
NASA Glenn Research Center
Cleveland Ohio, 44126, Summer 2011
• Create AutoCAD drawings for a carbon foam heat exchanger that was passed on for further thermal modeling and simulation analysis.
• Correlate pressure test data from the experimental heat exchanger and created a thermal math model for pressure correlation.
General Electric Aviation
West Chester, Ohio, Summer 2010, Co-op intern
• Reviewed turbine engine’s borescope inspections reports to determine improvements and relevant information that needs to be recorded in future inspections.
• Created a risk ma...
Login or Register to view the full resume.
